×Note:Special provisions may be very complex. The extracts are taken from
49 CFR §172.102. Please be careful with the information, as necessary, additional conditions may be applied that are not written here. Please check the original source and report bugs.
12 | In concentrations greater than 40 percent, this material has strong oxidizing properties and is capable of starting fires in contact with combustible materials. If appropriate, a package containing this material must conform to the additional labeling requirements of §172.402 of this subchapter. Browse special provision 12 |
---|
A60 | A60 Sterilization devices, when containing less than 30 mL per
inner packaging with not more than 150 mL per outer packaging, may be
transported in accordance with the provisions in Sec. 173.4a,
irrespective of Sec. 173.4a(b), provided such packagings were first
subjected to comparative fire testing. Comparative fire testing between
a package as prepared for transport (including the substance to be
transported) and an identical package filled with water must show that
the maximum temperature measured inside the packages during testing
does not differ by more than 200 [deg]C (392[emsp14][deg]F). Packagings
may include a vent to permit the slow escape of gas (i.e. not more than
0.1 mL/hour per 30 mL inner packaging at 20 [deg]C (68[emsp14][deg]F)
produced from gradual decomposition. The requirements of Sec. Sec.
173.24(g)(1) and 173.27(c) do not apply.
Browse special provision A60 |
---|
B53 | |
---|
B80 | |
---|
B81 | Venting and pressure relief devices for tank car tanks and cargo tanks must be approved by the Associate Administrator. Browse special provision B81 |
---|
B85 | |
---|
IB2 | Authorized IBCs: Metal (31A, 31B and 31N);
Rigid plastics (31H1 and 31H2); Composite
(31HZ1).
Additional Requirement: Only liquids with a
vapor pressure less than or equal to 110 kPa
at 50 [deg]C (1.1 bar at 122 [deg]F), or 130
kPa at 55 [deg]C (1.3 bar at 131 [deg]F) are
authorized. Browse special provision IB2 |
---|
IP5 | IBCs must have a device to allow venting. The
inlet to the venting device must be located
in the vapor space of the IBC under maximum
filling conditions. Browse special provision IP5 |
---|
T7 | |
---|
TP2 | a. The maximum degree of filling must not exceed the degree of filling determined by the following:  Where: t r is the maximum mean bulk temperature during transport, t f is the temperature in degrees celsius of the liquid during filling, and α is the mean coefficient of cubical expansion of the liquid between the mean temperature of the liquid during filling (t f) and the maximum mean bulk temperature during transportation (t r) both in degrees celsius. b. For liquids transported under ambient conditions α may be calculated using the formula:  Where: d 15 and d 50 are the densities (in units of mass per unit volume) of the liquid at 15 °C (59 °F) and 50 °C (122 °F), respectively. Browse special provision TP2 |
---|
TP6 | The tank must be equipped with a pressure release device which prevent a tank from bursting under fire engulfment conditions (the conditions prescribed in CGA pamphlet S-1.2 (see §171.7 of this subchapter) or alternative conditions approved by the Associate Administrator may be used to consider the fire engulfment condition), taking into account the properties of the hazardous material to be transported. Browse special provision TP6 |
---|
TP24 | The portable tank may be fitted with a device to prevent the build up of excess pressure due to the slow decomposition of the hazardous material being transported. The device must be in the vapor space when the tank is filled under maximum filling conditions. This device must also prevent an unacceptable amount of leakage of liquid in the case of overturning. Browse special provision TP24 |
---|
TP37 | IM portable tanks are only authorized for the shipment of hydrogen peroxide solutions in water containing 72% or less hydrogen peroxide by weight. Pressure relief devices shall be designed to prevent the entry of foreign matter, the leakage of liquid and the development of any dangerous excess pressure. In addition, the portable tank must be designed so that internal surfaces may be effectively cleaned and passivated. Each tank must be equipped with pressure relief devices conforming to the following requirements: Concentration of hydrogen per peroxide solution | Total1 |
---|
52% or less | 11 | Over 52%, but not greater than 60% | 22 | Over 60%, but not greater than 72% | 32 | 1Total venting capacity in standard cubic feet hour (S.C.F.H.) per pound of hydrogen peroxide solution. Browse special provision TP37 |
---|