This entry is signed with "D". The letter "D" identifies proper shipping names which are appropriate for describing materials for domestic transportation but may be inappropriate for international transportation under the provisions of international regulations (e.g., IMO, ICAO). An alternate proper shipping name may be selected when either domestic or international transportation is involved.
This entry is signed with "G". The letter "G" identifies proper shipping names for which one or more technical names of the hazardous material must be entered in parentheses, in association with the basic description. (See §172.203(k)).
×Note:Special provisions may be very complex. The extracts are taken from 49 CFR §172.102. Please be careful with the information, as necessary, additional conditions may be applied that are not written here. Please check the original source and report bugs. | 384 | For green graphite electrodes and shapes that are large single
component solid objects not subject to shifting, transport in open rail
flat cars, open bed motor vehicles, and intermodal containers is also
authorized. The objects must be secured to the flat car, motor vehicle,
intermodal container, or unitized by steel banding to wooden runners or
pallets and the units secured to the flat car, motor vehicle, or
freight container to prevent shifting and movement, including relative
motion between the objects, under conditions normally incident to
transportation. Stacking is permitted two or more levels high to
achieve maximum allowable utilization of the designated vehicle, rail
car weight, or intermodal freight container weight or vessel hold
volume. Browse special provision 384 |
|---|
| B54 | |
|---|
| IB8 | Authorized IBCs: Metal (11A, 11B, 11N, 21A,
21B, 21N, 31A, 31B and 31N); Rigid plastics
(11H1, 11H2, 21H1, 21H2, 31H1 and 31H2 );
Composite (11HZ1, 11HZ2, 21HZ1, 21HZ2 and
31HZ1); Fiberboard (11G); Wooden (11C, 11D
and 11F); Flexible (13H1, 13H2, 13H3, 13H4,
13H5, 13L1, 13L2, 13L3, 13L4, 13M1 or 13M2). Browse special provision IB8 |
|---|
| IP2 | When IBCs other than metal or rigid plastics
IBCs are used, they must be offered for
transportation in a closed freight container
or a closed transport vehicle. Browse special provision IP2 |
|---|
| T1 | |
|---|
| TP33 | The portable tank instruction assigned for this substance applies for granular and powdered solids and for solids which are filled and discharged at temperatures above their melting point which are cooled and transported as a solid mass. Solid substances transported or offered for transport above their melting point are authorized for transportation in portable tanks conforming to the provisions of portable tank instruction T4 for solid substances of packing group III or T7 for solid substances of packing group II, unless a tank with more stringent requirements for minimum shell thickness, maximum allowable working pressure, pressure-relief devices or bottom outlets are assigned in which case the more stringent tank instruction and special provisions shall apply. Filling limits must be in accordance with portable tank special provision TP3. Solids meeting the definition of an elevated temperature material must be transported in accordance with the applicable requirements of this subchapter. Browse special provision TP33 |
|---|
|
