HazMat Tool — substance information

Flammable liquids, corrosive, n.o.s.

HMT May 2026

UN / ID: UN 2924
Hazard class: 3
Packing group: I (multiple — see tabs)
ERG guide: ERG 132
Special provisions: SP T14, SP TP2
Source: 49 CFR §172 (2026/05)

Spot an error in this entry?

On this page

Flammable liquids, corrosive, n.o.s.

Flammable liquids are:

A liquid having a flash point of = 60.5° C (141° F)
Any material in a liquid phase with a flash point = 37.8° C (100° F) that is intentionally heated and offered for transport or transported at or above its flash point in bulk packaging.

More Information

Emergency Response Guide No. 132

Hazardous Materials Table

Source: 49 CFR §172 (2026/05)

Packing group I
Packing group II
Packing group III

(3) Hazard Class

3
Flammable liquids

This entry is signed with "G". The letter "G" identifies proper shipping names for which one or more technical names of the hazardous material must be entered in parentheses, in association with the basic description. (See §172.203(k)).

(7) Special Provisions (§172.102)

×Note:
Special provisions may be very complex. The extracts are taken from 49 CFR §172.102. Please be careful with the information, as necessary, additional conditions may be applied that are not written here. Please check the original source and report bugs.

T14

Minimum test pressure (bar)	6
Minimum shell thickness	6 mm
Pressure-relief requirements	§ 178.275(g)(3)
Bottom opening requirements	Prohibited

Browse special provision T14

TP2

a. The maximum degree of filling must not exceed the degree of filling determined by the following:
TP2a

Where:
t_r is the maximum mean bulk temperature during transport,
t_f is the temperature in degrees celsius of the liquid during filling, and
α is the mean coefficient of cubical expansion of the liquid between the mean temperature of the liquid during filling (t_f) and the maximum mean bulk temperature during transportation (t_r) both in degrees celsius.
b. For liquids transported under ambient conditions α may be calculated using the formula:
TP2b

Where:
d₁₅ and d₅₀ are the densities (in units of mass per unit volume) of the liquid at 15 °C (59 °F) and 50 °C (122 °F), respectively.

Browse special provision TP2

(8) Packing Authorizations (§173.***)

(8A) Exceptions	None
(8B) Non-bulk	201	see 49 CFR §173.201
(8C) Bulk	243	see 49 CFR §173.243

(9) Quantity Limits

(9A) Passenger aircraft/rail	0.5 L
(9B) Cargo aircraft only	2.5 L

(10) Vessel stowage

(10A) Location

Stowage category “E” means the material may be stowed “on deck” or “under deck” on a cargo vessel or on a passenger vessel carrying a number of passengers limited to not more than the larger of 25 passengers, or one passenger per each 3 m of overall vessel length, but is prohibited from carriage on a passenger vessel in which the limiting number of passengers is exceeded.

Source: 49 CFR §172.101(k)

(10B) Other

40	see 49 CFR §176.84

Source: 49 CFR §176.84

(3) Hazard Class

3
Flammable liquids

(4) Identification number

UN 2924

(5) Packing Group

Comparison View of PG

(6) Labels

(1) Symbols

(7) Special Provisions (§172.102)

IB2

Authorized IBCs: Metal (31A, 31B and 31N); Rigid plastics (31H1 and 31H2); Composite (31HZ1).
Additional Requirement: Only liquids with a vapor pressure less than or equal to 110 kPa at 50 °C (1.1 bar at 122 °F), or 130 kPa at 55 °C (1.3 bar at 131 °F) are authorized.

Browse special provision IB2

T11

Minimum test pressure (bar)	6
Minimum shell thickness	§ 178.274(d)(2)
Pressure-relief requirements	Normal
Bottom opening requirements	§ 178.275(d)(3)

Browse special provision T11

TP2

a. The maximum degree of filling must not exceed the degree of filling determined by the following:
TP2a

Where:
d₁₅ and d₅₀ are the densities (in units of mass per unit volume) of the liquid at 15 °C (59 °F) and 50 °C (122 °F), respectively.

Browse special provision TP2

TP27

A portable tank having a minimum test pressure of 4 bar (400 kPa) may be used provided the calculated test pressure is 4 bar or less based on the MAWP of the hazardous material, as defined in §178.275, where the test pressure is 1.5 times the MAWP.

Browse special provision TP27

(8) Packing Authorizations (§173.***)

(8A) Exceptions	150	see 49 CFR §173.150
(8B) Non-bulk	202	see 49 CFR §173.202
(8C) Bulk	243	see 49 CFR §173.243

(9) Quantity Limits

(9A) Passenger aircraft/rail	1 L
(9B) Cargo aircraft only	5 L

(10) Vessel stowage

(10A) Location

Stowage category “B” means

(i) The material may be stowed “on deck” or “under deck” on a cargo vessel and on a passenger vessel carrying a number of passengers limited to not more than the larger of 25 passengers, or one passenger per each 3 m of overall vessel length; and
(ii) “On deck only” on passenger vessels in which the number of passengers specified in paragraph (k)(2)(i) of this section is exceeded.

Source: 49 CFR §172.101(k)

(10B) Other

40	see 49 CFR §176.84

Source: 49 CFR §176.84

(3) Hazard Class

3
Flammable liquids

(4) Identification number

UN 2924

(5) Packing Group

III

Comparison View of PG

(6) Labels

(1) Symbols

(7) Special Provisions (§172.102)

If the material has a flash point at or above 38 °C (100 °F) and below 93 °C (200 °F), then the bulk packaging requirements of §173.241 are applicable. If the material has a flash point of less than 38 °C (100 °F), then the bulk packaging requirements of §173.242 are applicable.

Browse special provision B1

IB3

Authorized IBCs: Metal (31A, 31B and 31N); Rigid plastics (31H1 and 31H2); Composite (31HZ1 and 31HA2, 31HB2, 31HN2, 31HD2 and 31HH2).
Additional Requirement: Only liquids with a vapor pressure less than or equal to 110 kPa at 50 °C (1.1 bar at 122 °F), or 130 kPa at 55 °C (1.3 bar at 131 °F) are authorized, except for UN2672 (also see special provision IP8 in Table 2 for UN2672).

Browse special provision IB3

Minimum test pressure (bar)	4
Minimum shell thickness	§ 178.274(d)(2)
Pressure-relief requirements	Normal
Bottom opening requirements	§ 178.275(d)(3)

Browse special provision T7

TP1

The maximum degree of filling must not exceed the degree of filling determined by the following:
TP1

Where:
t_r is the maximum mean bulk temperature during transport, and t_f is the temperature in degrees celsius of the liquid during filling.

Browse special provision TP1

TP28

A portable tank having a minimum test pressure of 2.65 bar (265 kPa) may be used provided the calculated test pressure is 2.65 bar or less based on the MAWP of the hazardous material, as defined in §178.275, where the test pressure is 1.5 times the MAWP.

Browse special provision TP28

(8) Packing Authorizations (§173.***)

(8A) Exceptions	150	see 49 CFR §173.150
(8B) Non-bulk	203	see 49 CFR §173.203
(8C) Bulk	242	see 49 CFR §173.242

(9) Quantity Limits

(9A) Passenger aircraft/rail	5 L
(9B) Cargo aircraft only	60 L

(10) Vessel stowage

(10A) Location

Stowage category “A” means the material may be stowed “on deck” or “under deck” on a cargo vessel or on a passenger vessel.

Source: 49 CFR §172.101(k)

(10B) Other

40	see 49 CFR §176.84

Source: 49 CFR §176.84

Packing group comparison

Multiple packing groups apply to this entry. See assignment criteria in 49 CFR §173 Subpart D. Details are in the tabs above; differences are highlighted.

	PG I	PG II	PG III
1	G	G	G
2	Flammable liquids, corrosive, n.o.s.	Flammable liquids, corrosive, n.o.s.	Flammable liquids, corrosive, n.o.s.
3	3	3	3
4	UN 2924	UN 2924	UN 2924
5	I	II	III
6	3, 8	3, 8	3, 8
7	T14, TP2	IB2, T11, TP2, TP27	B1, IB3, T7, TP1, TP28
8A	None	150	150
8B	201	202	203
8C	243	243	242
9A	0.5 L	1 L	5 L
9B	2.5 L	5 L	60 L
10A	E	B	A
10B	40	40	40

Segregation chart for load, transport, and storage

This chart shows whether loading, transport, or storage with other hazard classes is permitted, prohibited, or restricted. Based on 49 CFR §177.848.

Hazard class	8	7	6.1	5.2	5.1	4.3	4.2	4.1	3	2.3B	2.3A	2.2	2.1	1.6	1.5	1.4	1.3	1.1/1.2
1.1/1.2
1.3
1.4
1.5
1.6
2.1
2.2
2.3A
2.3B
3
4.1
4.2
4.3
5.1
5.2
6.1
7
8

	Must not be loaded, transported, or stored together in the same vehicle or facility.
	May be loaded, transported, or stored together.
	May be loaded, transported, or stored together only with restrictions.

Similar substances

UN / ID	Proper shipping name	Hazard class
UN 3514	Adsorbed gas, toxic, flammable, n.o.s. Inhalation hazard zone A	2.3
UN 3514	Adsorbed gas, toxic, flammable, n.o.s. Inhalation hazard zone B	2.3
UN 3514	Adsorbed gas, toxic, flammable, n.o.s. Inhalation hazard zone C	2.3
UN 3514	Adsorbed gas, toxic, flammable, n.o.s. Inhalation hazard zone D	2.3
UN 1950	Aerosols, flammable, (each not exceeding 1 L capacity)	2.1
UN 1950	Aerosols, non-flammable, (each not exceeding 1 L capacity)	2.2
UN 3160	Liquefied gas, toxic, flammable, n.o.s. Inhalation Hazard Zone C	2.3
UN 3160	Liquefied gas, toxic, flammable, n.o.s. Inhalation Hazard Zone D	2.3
UN 3505	Chemical under pressure, flammable, corrosive, n.o.s	2.1
UN 3181	Metal salts of organic compounds, flammable, n.o.s	4.1
UN 2742	Chloroformates, toxic, corrosive, flammable, n.o.s	6.1
UN 3362	Chlorosilanes, toxic, corrosive, flammable, n.o.s	6.1
UN 2988	Chlorosilanes, water-reactive, flammable, corrosive, n.o.s	4.3
UN 0399	Bombs with flammable liquid, with bursting charge	1.1J
UN 0400	Bombs with flammable liquid, with bursting charge	1.2J