(3) Hazard Class 4.3
Dangerous when wet materials
Special provisions may be very complex. The extracts are taken from 49 CFR §172.102
. Please be careful with the information, as necessary, additional conditions may be applied that are not written here. Please check the original source and report bugs.
Combination packagings consisting of outer fiber drums or plywood drums, with inner plastic packagings, are not authorized for transportation by aircraft.
Browse special provision A19
Aluminum construction materials are not authorized for any part of a packaging which is normally in contact with the hazardous material.
Browse special provision N34
This material is not authorized in the following packagings:
- a. A combination packaging consisting of a 4G fiberboard box with inner receptacles of glass or earthenware;
- b. A single packaging of a 4C2 sift-proof, natural wood box; or
c. A composite packaging 6PG2 (glass, porcelain or stoneware receptacles within a fiberboard box).
Browse special provision N40
The portable tank instruction assigned for this substance applies for granular and powdered solids and for solids which are filled and discharged at temperatures above their melting point which are cooled and transported as a solid mass. Solid substances transported or offered for transport above their melting point are authorized for transportation in portable tanks conforming to the provisions of portable tank instruction T4 for solid substances of packing group III or T7 for solid substances of packing group II, unless a tank with more stringent requirements for minimum shell thickness, maximum allowable working pressure, pressure-relief devices or bottom outlets are assigned in which case the more stringent tank instruction and special provisions shall apply. Filling limits must be in accordance with portable tank special provision TP3. Solids meeting the definition of an elevated temperature material must be transported in accordance with the applicable requirements of this subchapter.
Browse special provision TP33
|(9A) Passenger aircraft/rail||15 kg|
|(9B) Cargo aircraft only||50 kg|
Stowage category “D” means the material must be stowed “on deck only” on a cargo vessel or on a passenger vessel carrying a number of passengers limited to not more than the larger of 25 passengers or one passenger per each 3 m of overall vessel length, but the material is prohibited on a passenger vessel in which the limiting number of passengers is exceeded.
Source: 49 CFR §172.101(k)
|13||Keep as dry as reasonably practicable.|
|52||Stow “separated from” acids.1 2|
|148||see 49 CFR §176.84|
1For waste cyanides or waste cyanide mixtures or solutions, refer to §173.12(e) of this subchapter.
2 Class 8 materials in PG II or III that otherwise are required to be segregated from one another may be transported in the same cargo transport unit, whether in the same packaging or not, provided the substances do not react dangerously with each other to cause combustion and/or evolution of considerable heat, or of flammable, toxic or asphyxiant gases, or the formation of corrosive or unstable substances; and the package does not contain more than 30 L (7.8 gallons) for liquids or 30 kg (66 lbs.) for solids.
Source: 49 CFR §176.84