HazMat Tool — substance information Reference only — not a shipping paper, placard mandate, or CVI record.

Carbon disulfide

HMT 15 June 2026

UN / ID: UN 1131
Hazard class: 3
Packing group: I
ERG guide: ERG 131
Special provisions: SP B16, SP T14, SP TP2, SP TP7, SP TP13, SP W31
Source: 49 CFR §172 (15 June 2026)

On this page

Carbon disulfide

Carbon disulfide (also spelled as carbon disulphide) is an inorganic compound with the chemical formula CS2 and structure S=C=S. It is also considered as the anhydride of thiocarbonic acid. It is a colorless, flammable, neurotoxic liquid that is used as a building block in organic synthesis. Pure carbon disulfide has a pleasant, ether- or chloroform-like odor, but commercial samples are usually yellowish and are typically contaminated with foul-smelling impurities Wikipedia

Substance Data

Source: PubChem (HSDB, 22.10.2026)

CAS-Number

75-15-0

Flash Point

-30 ° C

Boiling Point

46.2 ° C

Emergency Response Guide No. 131

Hazardous Materials Table

Source: 49 CFR §172 (15 June 2026)

(3) Hazard class

3
Flammable liquids

(4) Identification number

UN 1131

(5) Packing Group

(6) Labels

(7) Special Provisions (§172.102)

×Note:
Special provisions may be very complex. The extracts are taken from 49 CFR §172.102. Please be careful with the information, as necessary, additional conditions may be applied that are not written here. Please check the original source and report bugs.

B16

The lading must be completely covered with nitrogen, inert gas or other inert materials.

Browse special provision B16

T14

Minimum test pressure (bar)	6
Minimum shell thickness	6 mm
Pressure-relief requirements	§ 178.275(g)(3)
Bottom opening requirements	Prohibited

Browse special provision T14

TP2

a. The maximum degree of filling must not exceed the degree of filling determined by the following:
TP2a

Where:
t_r is the maximum mean bulk temperature during transport,
t_f is the temperature in degrees celsius of the liquid during filling, and
α is the mean coefficient of cubical expansion of the liquid between the mean temperature of the liquid during filling (t_f) and the maximum mean bulk temperature during transportation (t_r) both in degrees celsius.
b. For liquids transported under ambient conditions α may be calculated using the formula:
TP2b

Where:
d₁₅ and d₅₀ are the densities (in units of mass per unit volume) of the liquid at 15 °C (59 °F) and 50 °C (122 °F), respectively.

Browse special provision TP2

TP7

The vapor space must be purged of air by nitrogen or other means.

Browse special provision TP7

TP13

Self-contained breathing apparatus must be provided when this hazardous material is transported by sea.

Browse special provision TP13

W31

Non-bulk packagings must be hermetically sealed.

Browse special provision W31

(8) Packing Authorizations (§173.***)

(8A) Exceptions	None
(8B) Non-bulk	201	see 49 CFR §173.201
(8C) Bulk	243	see 49 CFR §173.243

(9) Quantity Limits

(9A) Passenger aircraft/rail	Forbidden
(9B) Cargo aircraft only	Forbidden

(10) Vessel stowage

(10A) Location

Stowage category “D” means the material must be stowed “on deck only” on a cargo vessel or on a passenger vessel carrying a number of passengers limited to not more than the larger of 25 passengers or one passenger per each 3 m of overall vessel length, but the material is prohibited on a passenger vessel in which the limiting number of passengers is exceeded.

Source: 49 CFR §172.101(k)

(10B) Other

40	see 49 CFR §176.84
78	see 49 CFR §176.84
115	see 49 CFR §176.84

Source: 49 CFR §176.84

Segregation chart for load, transport, and storage

This chart shows whether loading, transport, or storage with other hazard classes is permitted, prohibited, or restricted. Based on 49 CFR §177.848.

Hazard class	8	7	6.1	5.2	5.1	4.3	4.2	4.1	3	2.3B	2.3A	2.2	2.1	1.6	1.5	1.4	1.3	1.1/1.2
1.1/1.2
1.3
1.4
1.5
1.6
2.1
2.2
2.3A
2.3B
3
4.1
4.2
4.3
5.1
5.2
6.1
7
8

	Must not be loaded, transported, or stored together in the same vehicle or facility.
	May be loaded, transported, or stored together.
	May be loaded, transported, or stored together only with restrictions.

Similar substances

UN / ID	Proper shipping name	Hazard class
UN 1556	Arsenic compounds, liquid, n.o.s. inorganic, including arsenates, n.o.s.; arsenites, n.o.s.; arsenic sulfides, n.o.s.; and organic compounds of arsenic, n.o.s	6.1
UN 1557	Arsenic compounds, solid, n.o.s. inorganic, including arsenates, n.o.s.; arsenites, n.o.s.; arsenic sulfides, n.o.s.; and organic compounds of arsenic, n.o.s	6.1
UN 1382	Potassium sulfide, anhydrous or Potassium sulfide with less than 30 percent water of crystallization	4.2
UN 1385	Sodium sulfide, anhydrous or Sodium sulfide with less than 30 percent water of crystallization	4.2
UN 0401	Dipicryl sulfide, dry or wetted with less than 10 percent water, by mass	1.1D
UN 2852	Dipicryl sulfide, wetted with not less than 10 percent water, by mass	4.1
UN 1847	Potassium sulfide, hydrated with not less than 30 percent water of crystallization	8
UN 2949	Sodium hydrosulfide with not less than 25 percent water of crystallization	8
UN 2318	Sodium hydrosulfide, with less than 25 percent water of crystallization	4.2
UN 1849	Sodium sulfide, hydrated with not less than 30 percent water	8
UN 1339	Phosphorus heptasulfide, free from yellow or white phosphorus	4.1
UN 1340	Phosphorus pentasulfide, free from yellow or white phosphorus	4.3
UN 1341	Phosphorus sesquisulfide, free from yellow or white phosphorus	4.1
UN 1343	Phosphorus trisulfide, free from yellow or white phosphorus	4.1
	Antimony sulfide and a chlorate, mixtures of	Forbidden